Re: stdapi-term not updating process monitor status

["Rao, Sam" <Sam_Rao@AFCC.COM>]

Glen,

Just a couple of thoughts...

I assume you must be calling stdapi-init -- this is where the variable used
to update the process status in stadapi-term is set to successful. If
stdapi-init was called, then the problem is probably in eoj.sqc -- I would
use a Display/Show statement  to display the contents of #return-status:
this should be equal to Good-OS-Status defined in setenv.sqc for your OS. If
the Good-OS-Status looks good then there is a problem while updating the
PSPRCSRQST table -- check SQR.LOG to see if any SQL-statement error message
exists!

Hope this helps!

Sam Rao




> -----Original Message-----
> From: Ackerson, Glenn [SMTP:Gsacker@IS.UNCO.EDU]
> Sent: Friday, August 20, 1999 2:55 PM
> To:   Multiple recipients of list SQR-USERS
> Subject:      stdapi-term not updating process monitor status
>
> Greetings all,
>   I was wondering if anyone else has had a problem with an sqr not
> updating the process monitor status, even though the sqr program
> calls the stdapi-term sqc? I've written a number of sqr's which use
> this routine successfully, but for some reason this one problem sqr
> always leaves the process monitor status as "processing" and
> never updates it to "success." When I look at this problem sqr and
> look at others I've written, performing a "do stdapi-term" I can't see
> a visible difference. Any thoughts anyone? Thanks in advance for
> your feedback.
>
> Regards,
> Glenn Ackerson
> **************************************************
> Glenn Ackerson
> Information Technology Professional III
> Internet Address: gsacker@is.unco.edu
> University of Northern Colorado
> Information Services
> Carter Hall   Greeley, CO  80639