Re: stdapi-term not updating process monitor status

["Wendel, Robbi" <rwendel@NESPOWER.COM>]

We had a similar problem, we resolved it with this little bit of added
code....

begin-procedure Terminate
   if #prcs_process_instance > 0
      do Update-Prcs-Run-Status
   end-if
   do Reset
end-procedure

hope this helps.
Robbi
-----Original Message-----
From: Ackerson, Glenn [mailto:Gsacker@IS.UNCO.EDU]
Sent: Friday, August 20, 1999 2:55 PM
To: Multiple recipients of list SQR-USERS
Subject: stdapi-term not updating process monitor status


Greetings all,
  I was wondering if anyone else has had a problem with an sqr not
updating the process monitor status, even though the sqr program
calls the stdapi-term sqc? I've written a number of sqr's which use
this routine successfully, but for some reason this one problem sqr
always leaves the process monitor status as "processing" and
never updates it to "success." When I look at this problem sqr and
look at others I've written, performing a "do stdapi-term" I can't see
a visible difference. Any thoughts anyone? Thanks in advance for
your feedback.

Regards,
Glenn Ackerson
**************************************************
Glenn Ackerson
Information Technology Professional III
Internet Address: gsacker@is.unco.edu
University of Northern Colorado
Information Services
Carter Hall   Greeley, CO  80639