Re: sqr supplied tools

[DarnielleC <DarnielleC@HONCOMPANY.COM>]

I was trying to show you an example of a failure situation.  The -ZIV flag
allows me to have the report generated automatically passed to the viewing
program.  Of course, at this time instead of sqrv.exe program launching, it
errors out.  The -ZIF flag is set on my command line and is pointing to
p:\HR750\sqr\pssqr.ini.  Currently, the section in this file is set to.

[Environment:Common]
SQRDIR=dummy

Obviously this looks wrong, but I have tried setting it to the correct path
of my SQR executables and have had no effect, even rebooted my workstation.
I have also tried doing a set command in my autoexec.bat file.  It's really
strange because I would have thought one of the above would have corrected
the issue.

Not that I think it should matter but, as most people have implied there is
an sqr.ini file.  My installation doesn't have this file anywhere, I assume
that the file pssqr.ini is it with a different name.  Also this file is
running off a network drive, there shouldn't be a problem with this should
there?  Do I need this file locally?

> -----Original Message-----
> From: Tom Hippensteel [SMTP:THippensteel@SPECTRUMHEALTH.COM]
> Sent: Wednesday, November 11, 1998 5:25 PM
> To:   Multiple recipients of list SQR-USERS
> Subject:      Re: sqr supplied tools
>
> Isn't the command flag '-ZIF'. not '-ZIV'?
>
> > -----Original Message-----
> > From: DarnielleC [SMTP:DarnielleC@HONCOMPANY.COM]
> > Sent: Wednesday, November 11, 1998 4:04 PM
> > To:   Multiple recipients of list SQR-USERS
> > Subject:      sqr supplied tools
> >
> > Hello,
> >
> > I'm having a problem running any of the sqr supplied tools, in
> particular
> > sqr viewer.  If I try to run an sqr with the -ZIV command flag I get the
> > following error message:  (SQR 14)  The required environmental variable
> > SQRDIR has not been defined.  I have also tried running these programs
> > (i.e.
> > sqrv.exe, sqrj.exe, etc.) directly and receive the same results.
> >
> > There was a post a week or so back with the same error message, and I
> > tried
> > the suggested fixes with no luck.  I have tried set statements in my
> > autoexec.bat and altering my pssqr.ini file.  I'm not really sure where
> > else
> > to look, I contacted PeopleSoft for support but they drew a blank too.
> > I'm
> > considering contact SQRIBE directly, unless anyone has any ideas?
> >
> > SQR  v4.2.3
> >
> > Thanks.
> > ----
> > Chad Darnielle
> > The HON Company, IT Programmer/Analyst
> > * 319-264-7578   * DarnielleC@honcompany.com