Footing question

[Darwin Anderson <dander03@AVIS.COM>]

I have the following footing.  When I use the
delivered 'setup01a.sqc' (code below) it prints as expected,
at the bottom of each page.

But, when I try to use the attached Declare-Printer and
Declare-Layout code the footing appears at the bottom of the
first page.  On every subsequent page, appears at the TOP
of an otherwise blank page.  It looked like the top to bottom
page size was whacked out causing the footing to wrap to
a new page ( the Max-lines command).

I have varied the max-lines from 40 to 60 without any change
in results.

+++++++++++++++ footing section code +++++++++++++

BEGIN-FOOTING 2

IF $report_end = 'N'
  PRINT 'PAC Contribution Report continues'  (2)  Center
ELSE
  PRINT 'END OF PAC Contribution Report (AL_PACrp)'
(2)  Center
END-IF

END-FOOTING



++++++++++   Setup section code +++++++++++++++++

BEGIN-SETUP
THIS STMT PRODUCES CORRECT FOOTINGS

#INCLUDE 'setup01a.sqc'

+++++++++++++++++++++++++++++++++++++++++++

THIS STMT PRODUCES INCORRECT FOOTINGS

DECLARE-PRINTER HP-DEFINITION        ! enlarged font
  TYPE=HP
  FONT=3
  PITCH=10
END-DECLARE

DECLARE-LAYOUT DEFAULT_PORTRAIT      ! portrait
  PAPER-SIZE=(8.5, 11.0)
  LEFT-MARGIN=0.5
  RIGHT-MARGIN=0.5
  MAX-LINES=52
  ORIENTATION=PORTRAIT           ! 75 columns for printing
END-DECLARE

END-SETUP
+++++++++++++++++++++++++++++++++++++++++

I'm running on SYBASE 11.0.2.1
SQRW 3.0.13.2

all advice greatly appreciated
TIA
Darwin Anderson
dander03@avis.com