Re: Duplex printing?

[John Kellogg <johnk@SQRIBE.COM>]

Have you tried the print-direct instead of print as Ray recommended in
his reply. All of our HelpDesk cases mention that print-direct must be
used.

John L. Kellogg
SQRiBE Technologies Support Manager


Shawn Dunn wrote:
>
> Ray,
>
> This is the code that I'm using:
>
>   encode '<27>&l1S' into $duplex
>
>   print $duplex (,+1)
>
> If I use the print command at the beginning of the program only, I get the
> output of page 2 written over page 1.
>
> If I use the print command at the beginning of the program and where the
> second page of output starts, I get 2 seperate pages of output.
>
> Any other ideas?
>
> TIA.
>
> Shawn
>
> >> Has anyone had any luck printing duplex forms from within SQR?
> >
> >I'm not sure about this, but are you using PRINT-DIRECT to send
> >the command to the printer?  Is it preceded by an escape character?
> >You may need to use the ENCODE command to get an escape character
> >onto the front of the escape sequence.
> >
> >Ray
>
> -------------------------------
> Shawn Dunn - SDUNN@MIT.EDU
> Analyst/Programmer III - MIT Bursar's Office, Cambridge, MA
> http://web.mit.edu/sdunn/www/