SQR Viewer questions

["Adem M. Hamidovic" <hamidoam@TUNS.CA>]

I've recently completed a report using SQR installed on a Sun. I've now
been told that it would be nice to see what the report would look like
in Windows before printing, so I downloaded the SQR Viewer. There are two
problems I've encountered so far:
        1) My report uses an .eps image in the header. When I try to view
the report in the viewer the image is unable to load. It can find the
image, but just prints an empty box.

        2) The page numbering in the viewer is off by a page. For
example, a two page report shows up as 'page 1 of 1', while a one page
report shows up as 'page 1 of 0'. Needless to say, when I attempt to go
to the last page in this case it blurts out an error.

Concerning question 1, do images viewed in the viewer have to be a certain
format? This report will always be going to a postscript printer, hence
the reason I was using the .eps format.

Concerning question 2, any ideas what's happening here?

Thanks again,
        Adem