General Protection Fault when using the -M switch in SQRW 2.5

["Mansfeld, Fredrik" <fredrik@ABARIS.SE>]

Hi,

I have run into some serious problems when trying to use the -M switch
in SQRW 2.5. I must increase the number of allowed #Define's in my
report
so I created a small file with only one row in it:
SUBVARS=250

However, as soon as I make my call to SQRW.EXE crasches with a GP fault
on address 0001:432E

According to the manual the -M switch only takes a file name as argument
and no path. It doesn't matter where I put the file or what I call it,
or
even if there are no file at all. I get the GP in all cases. What am I
doing wrong?

I run SQRW 2.5 in NT 3.51 on a Compaq Deskpro XL 5100 with plenty of RAM
and disk space, so I don't think it is a 'limited resources'-problem.


Any hints or suggestions are deeply appreciated.

Thanks in advance!
/Fredrik Mansfeld, Abaris AB, Sweden