RE: [sqr-users] distributing SQR output using portal API

["Paul Hoyte" <paul.hoyte@sharidionne.com>]

Andrew:

The SQR would have to dynamically create the API code that can be
dynamically executed from within the SQR (assuming your have the correct
privileges to do this) - Sample logic is provided in the Portal
directories under the integrator directory. Good luck with this one...

Paul Hoyte
(248) 752-6970 Cell
(248) 559-6868 Office
(248) 559-6875 Fax
paul.hoyte@sharidionne.com (Email)
www.sharidionne.com (Web Site)


-----Original Message-----
From: sqr-users-admin@sqrug.org [mailto:sqr-users-admin@sqrug.org] On
Behalf Of geek.unlimited@mindspring.com
Sent: Thursday, May 22, 2003 9:07 PM
To: sqr-users@sqrug.org
Subject: [sqr-users] distributing SQR output using portal API


SQR 6.2.1
Windows 2000
Portal 7.0.2

I am writing an SQR that will distribute reports to a hierarchy of
categories on the portal.  If possible, I would like to generate new
categories on the fly, as they are found in the data, but this is not
essential.  I am told that, to do this, I need to write portal API code
to distribute the reports after the job factory finishes.  I don't even
know where to look to find a sample piece of this code or to get
information on how it is done.  Anyone?  Since this is a bit outside the
strictly SQR realm, please reply to me, rather than the list.

Andrew :)

_______________________________________________
sqr-users mailing list
sqr-users@sqrug.org http://www.sqrug.org/mailman/listinfo/sqr-users

_______________________________________________
sqr-users mailing list
sqr-users@sqrug.org
http://www.sqrug.org/mailman/listinfo/sqr-users