Re: typo in previous question....

[Elvis Pressly <elvisdman@HOTMAIL.COM>]

Andrew,

When encoding sequence codes usually you only put the codes in one
continous line otherwise everytime it encounters a separate <27> then
your previous settings are gone. The micr encoding works fine
because I am sure it was the last reset before going to the
next record. Here's an example...

    encode '<27>&l0L<27>&l5H<27>&l3A' into $Page-Init


>From: Andrew Lin <alin@TECHNEGLAS.COM>
>Reply-To: sqr-users@list.iex.net
>To: SQR-USERS@list.iex.net
>Subject: typo in previous question....
>Date: Wed, 3 Apr 2002 16:45:14 -0500
>
>Should have read:
>
>!  ENCODE '<27>&l3A' INTO $legal_code
>!  print $legal_code (,) code
>
>   encode '<27>&l5H' into $tray3
>   print-direct printer=HPLASERJET $tray3
>
>!  encode '<27>&l3a5H' into $leg-tray3
>!  print-direct printer=HPLASERJET $leg-tray3
>
>(I had left in 0H instead of 5H... I've tried just
>about every number already(0-5)..seems to have
>no effect.)
>
>Thanks!
>
>-Andrew




_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com