Re: Simple SQRW.EXE output direction question

[Mark Risman <mrisman@PAINEWEBBER.COM>]

Stuart,

If you are trying to specify an "include" directory, you need to use -I instead 
of -F (I know this well since I had incorrectly suggested -F where the solution 
would have been  -I; this was in a post in response to a different question a 
couple of weeks ago).

- Mark

                -----Original Message-----
                From:   skohler@NORWICH.EDU [mailto:skohler@NORWICH.EDU]
                Sent:   Monday, April 10, 2000 1:58 PM
                To:     SQR-USERS@list.iex.net
                Subject:        Simple SQRW.EXE output direction question

                In attempting to pass the -f parameter using SQRW.EXE, I have 
tried
                variations of:

                     -fc:\temp\

                in an attempt to direct the output .lis file to the temp 
directory.

                This syntax results in the error:

                     <SQR 6002> Cannot open the printer file:
                     c:\temp\test.sqrc:\sqribe\sqr\ora\binw\test.spf

                Obviously, for some reason, the -f is not working as it does 
using sqr on
                unix...

                Thanks in advance for any suggestions,
                Stuart

                
--------------------------------------------------------------------
                Stuart Kohler, Programmer/Analyst
                Norwich University Computing Services
                Northfield, VT 05663
                voice: (802) 485-2383; fax: (802) 485-2291
                <skohler@norwich.edu>
                
--------------------------------------------------------------------