Re: Font Size in SQR??

[Tam Siu Tung <ton@HIGHED1.CYBEREC.COM>]

I would like to ask can I use the Font = 5 at the first part of the report
and then use Font = 8 at the middle partand then change back to font = 5
agin in the last part?
I try to change the font to bigger, but it can't change to smaller again!



On Thu, 6 Jan 2000, Mark Risman wrote:

> If you want to change the default font size or other similar attributes of the whole SQR, you can also use DECLARE-PRINTER (available in SQR 3 and up) or DECLARE PRINTER (deprecated in SQR 3 and up).
>
> - Mark
>
>                 -----Original Message-----
>                 From:   Ray Ontko [mailto:rayo@ONTKO.COM]
>                 Sent:   Thursday, January 06, 2000 8:21 AM
>                 To:     SQR-USERS@list.iex.net
>                 Subject:        Re: Font Size in SQR??
>
>                 Howdy,
>
>                 >         I would like to ask that how to change the font to be bigger in
>                 > SQR? My printer is Xerox 4215/MRP2!
>
>                 It appears that the Xerox 4215/MRP2 supports HP PCL and Adobe PostScript:
>
>                    http://www.mrsp.com/products/42154219/
>
>                 If you can figure out how to put the printer into PCL or PostScript
>                 "mode", then you can use SQR with -printer:hp or -printer:ps to
>                 generate PCL or PostScript output.
>
>                 Then, to change the font, use the ALTER-PRINTER command to change
>                 the font-size, character-set, type-face, etc.
>
>                 Ray
>                 ----------------------------------------------------------------------
>                 Ray Ontko   rayo@ontko.com   Phone 1.765.935.4283   Fax 1.765.962.9788
>                 Ray Ontko & Co.   Software Consulting Services   http://www.ontko.com/
>